Author: Domange, D.
Paper Title Page
THC2C1 Shower Simulations for the CERN Proton Synchrotron Internal Dump and Comparison with Beam Loss Monitor Data 389
 
  • S. Niang, L.S. Esposito, M. Giovannozzi, C. Hernalsteens, A. Huschauer, T. Pugnat
    CERN, Geneva, Switzerland
  • D. Domange
    ULB, Bruxelles, Belgium
 
  During the Long Shutdown 2 (LS2), two new internal dumps (TDIs) were installed and successfully put into operation in the CERN Proton Synchrotron (PS) to withstand the intense and bright beams produced for the High Luminosity LHC. TDIs serve as safety devices designed to rapidly enter the beam trajectory and stop the beam over multiple turns. Due to their design, the TDI only absorbs a fraction of the secondary particle shower produced by beam particles that impinge on it. Starting from impacts computed by multi-turn beam dynamics simulations, detailed shower simulations were performed with FLUKA to assess the radiation field’s impact on the downstream equipment, with a particular emphasis on the dose measured by Beam Loss Monitors. The numerical data obtained from the simulations are compared with the experimental data collected during PS operation.  
slides icon Slides THC2C1 [2.092 MB]  
DOI • reference for this paper ※ doi:10.18429/JACoW-HB2023-THC2C1  
About • Received ※ 28 September 2023 — Revised ※ 09 October 2023 — Accepted ※ 10 October 2023 — Issued ※ 29 October 2023
Cite • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
THBP36 Study of the Performance of the CERN Proton Synchrotron Internal Dump 555
 
  • T. Pugnat, L.S. Esposito, M. Giovannozzi, C. Hernalsteens, A. Huschauer, S. Niang
    CERN, Meyrin, Switzerland
  • D. Domange, E. Gnacadja, R. Tesse
    ULB, Bruxelles, Belgium
 
  In the framework of the LHC Injector Upgrade project, a new internal dump for the CERN Proton Synchrotron (PS) has been designed, installed, and successfully commissioned. This device is meant to move rapidly into the beam and stop charged particles over several turns to provide protection to the PS hardware against beam-induced damage. The performance of the dump should ensure efficient use throughout the PS energy range, i.e. from injection at 2 GeV (kinetic energy) to flat top at 26 GeV (total energy). In this paper, detailed numerical simulations are presented, carried out with a combination of sophisticated beam dynamics and beam-matter interaction codes, assessing the behaviour of stopped or scattered particles. The results of these numerical simulations are compared with the data collected during the routine operation of the PS and its internal dump.  
poster icon Poster THBP36 [0.609 MB]  
DOI • reference for this paper ※ doi:10.18429/JACoW-HB2023-THBP36  
About • Received ※ 26 September 2023 — Revised ※ 05 October 2023 — Accepted ※ 10 October 2023 — Issued ※ 28 October 2023
Cite • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)